![]() If you are unsure if you want to attempt this fix or if you can’t find a valve kit for your pad, reach out to the manufacturer to see what your other repair options are or if it is covered under their warranty. Follow the manufacturer provided instructions for the best results. The repair kit you purchase may have instructions that differ slightly. Once cured, inflate the sleeping pad and let it sit inflated for 8-12 hours to make sure the valve isn’t leaking.Let the adhesive cure for at least three hours.Avoid pushing the valve too far past the base. Carefully twist and push the new valve until it has fully seated into the valve opening on the pad.Apply a thin layer of adhesive around the outside of the barbed valve end. Clean the valve area before moving to the next steps.Hold the sleeping pad material below the pliers and pull away from the pad while twisting and pulling the valve straight out. Room & Care In Apple Valley We Accept IHSS. Then, using a pair of pliers, grab the valve cap at the base. Remove the broken valve by opening it as far as possible.Once you have the repair kit, follow these steps to repair the valve: Patches included in a supplied kit are likely the same material as the pad, making it easier for the fabrics to adhere together. Since many inflatable sleeping pads come with a patch kit, follow the directions provided in that kit as they may be specific to the company. If no air is escaping, your handiwork has paid off, and your sleeping pad is ready for use once again. Reinflate the sleeping pad to see if there is still a leak.For best results, let the patch sit and adhere overnight (8-12 hours).Press the patch down, smooth it out to eliminate air bubbles, and ensure it adheres to the pad.If you are using a patch kit, read the directions thoroughly before following these instructions, as they may differ according to the type of patch and adhesive. Apply the patch of your choice over the curing adhesive.It should at least cover the adhesive area but make it slightly larger just in case. If needed, cut the patch to extend at least ½ an inch out from the hole.When you’re finished, allow the mattress to dry completely. For a thorough clean, spread some of the isopropyl alcohol on a towel or cotton ball. Wipe the leak and the fabric around it to remove any debris. So, read the adhesive directions carefully before moving to the next step. 2 5 Clean the leaking area with isopropyl alcohol. Most adhesives need to be slightly tacky to work well. Depending on the adhesive you use, it may need time to set (20-30 minutes). The adhesive should extend at least a ½ inch out from the hole, but recommend going 1-2 inches around the hole for larger rips. Let the alcohol dry, and then apply a thin layer of adhesive. ![]() An alcohol wipe from your first aid kit will work just fine if you’re in the field. Once it is brushed off and free of dirt or debris, use isopropyl alcohol to prep the pad for the patch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |